Shangqiu Industrial Zone, Qinggang Town, Yuhuan, Zhejiang Province

ONLINE INQUIRY

Please be sure to fillin the information accurately, and keep the communication unblocked, we will get in touch with you as soon as possible

Safety Technical Operation Regulations for Electric Pickles

1. Please wear a hard hat (safety helmet), safety glasses

Release time:

2024-09-06

1. Please wear a hard hat (safety helmet), safety glasses, and a protective mask. It is also highly recommended to wear dust masks, ear protection, and thick padded gloves.
Before operation, it is necessary to confirm that the chisel is fastened in the designated position.
3. In general operation, this tool works by vibration. Therefore, screws are prone to loosening, leading to breakage or accidents. So before operation, it is necessary to carefully check whether the screws are tightened.
During cold seasons or when the tool has not been used for a long time, it should be allowed to run without load for a few minutes to heat the tool.
5. It is necessary to confirm standing in a sturdy place. When using tools at heights, it is necessary to confirm that there is no one below.
6. Hold the tool tightly with both hands
7. Do not touch tools with your hands
8. Do not remove the tool while rotating. The tool can only be started when the hand picks it up.
When operating, do not point the chisel at anyone present. Serious personal injury accidents may occur due to the possibility of the punch flying out
10. When chiseling into walls, floors, or any place where buried wires may be, never touch any metal parts of the tool. Hold the plastic handle or side grip of the tool to prevent electric shock caused by chiseling into buried wires.
11. After operation, do not immediately touch the chisel or parts close to the chisel. Because it may be very hot and burn the skin.